Pt/CeO2 catalysts during model redox sequences: origin of improvement for diesel exhaust - Université Claude Bernard Lyon 1 Accéder directement au contenu
Communication Dans Un Congrès Année : 2018

Pt/CeO2 catalysts during model redox sequences: origin of improvement for diesel exhaust

Résumé

1.Introduction The tailoring of Pt based diesel oxidation catalysts is crucial to enhance the efficiency of the diesel vehicles after treatment. For instance, specific interactions between Pt and ceria can improve the thermal stability of Pt nanoparticles (NPs) in an oxidizing atmosphere as in diesel exhausts, through the formation of rigid Pt-O-Ce bonds.1 More recently, Jones et al.2 have evidenced stabilization of Pt single atoms and clusters on ceria surface steps, strongly suggesting the doping of ceria subsurface by Pt cations in good agreement with DFT studies3 which also predict Pt2+ cations incorporation between surface oxygen ions species of the support. We have recently demonstrated the dynamic nature of Pt NPs on ceria under reducing/oxidizing sequences at temperatures below 500 °C.4 Lean/rich pulses can be used to control the formation of Pt NPs and enhance their catalytic activity for CO oxidation.4 This study aims at getting new insights into the impact of redox sequences on the Pt and CeO2 interactions. 2.Experimental/methods Ceria provided by Solvay Special Chem. Company was dry impregnated with Pt (0.9 wt %) and calcined 4 h at 500 °C. Before each characterization or catalytic test, the catalyst was systematically pretreated in O2 for 1 h at 500 °C to get a reference state. Model redox sequences were composed of a first reduction step of 1 h in 10% H2 followed by an oxidation one also of 1 h in 20% oxygen. They were performed at different temperatures: 500/500 °C (reduction/oxidation), 250/250 °C and 250 °C/RT. Catalytic performances were measured for CO and propylene oxidation in a lean mixture (10% O2, 1000 ppm CO, 500 ppm NO, 500 ppm C3H6, 10% H2O in He) that simulates diesel exhaust gas. Temperature-Programmed Reduction (TPR) experiments were conducted with a Inficon JPC400 mass spectrometer. STEM observations were performed with an Environmental Transmission Electron Microscope (Ly-ETEM, FEI TITAN ETEM operated at 300 kV). The spatial distribution of surface oxygen electrophilic species and PtOx clusters were assessed by Raman spectroscopy mapping at the micrometric level (200 µm x 200 µm) recorded at RT under oxygen flow. HRXANES was also implemented to in situ follow the oxidation degree of Ce cations in the catalyst. 3.Results and discussion As previously observed with rich/lean pulses,4 model redox sequences can achieve outstanding catalytic performances for CO and C3H6 oxidation, much higher than those recorded at the reference state. TPR experiments have shown that model redox sequences increase the reducibility of ceria. The H2 consumption only starts above 150 °C on the first TPR, suggesting the absence of Pt NPs able to chemisorb H2 below this temperature, as confirmed by STEM observations. Successive redox sequences (TPR 2 and TPR 3) promote the formation of Pt NPs in strong interaction with ceria as shown by the excellent reducibility of the support as early as the room temperature. The lower the temperature of the redox sequences, the greater the reducibility. Variations of the Raman band associated with PtOx at 690 cm-1 demonstrate that such species evolve upon redox sequences with stabilization of Pt cations in another oxidation state, probably Pt2+, as suggested by XPS measurements and DFT calculations.3 These Pt2+ cations are in interaction with peroxo oxygen species (Raman bands at 860 cm-1). No Ce3+ cations were detected both by electronic Raman spectroscopy and HR-XANES measurements, confirming that these oxygen peroxo species did not re-oxidized ceria but are stabilized on the surface. The shape of the Pt NPs was followed along the redox sequences. After the first reduction step, only raft shaped particles or single atoms are observed on the surface (Fig. 1c). This morphology is not modified after a subsequent oxidation step but the surface mean diameter of Pt rafts slightly increases from 1.0 to 1.3 nm, maybe due to Pt oxidation. Statistics on the ratio between the number of rafts and single atoms were tricky to estimate. However, CO chemisorption performed after each reduction step shows no significant modification of the Pt dispersion along the redox cycles. 4.Conclusions This work showed that raft shaped Pt nanoparticles in closed interaction with ceria can be stabilized by model redox sequences at mild temperatures. This maximizes the Pt/ceria interface, promoting the oxygen transfer from the support towards Pt which is a key step in the CO oxidation mechanism. Pt cations are stabilized in an intermediate oxidation state, probably Pt2+, in interaction with peroxo oxygen species, confirming the high availability of oxygen species for oxidation reactions. Acknowledgement French National Research agency ‘Agence Nationale de la Recherche’ (ANR), project ORCA (ANR-14-CE22-0011-02) and German Federal Ministry for Economic Affairs and Energy (BMWi) are acknowledged for their financial support. The authors thank Solvay Special Chem Company for material contribution and the CLYM for access to the Ly-EtTEM. References [1]Y. Nagai, K. Dohmae, Y. Ikeda, N. Takagi, T. Tanabe, N. Hara, G. Guilera, S. Pascarelli, M.A. Newton, O. Kuno, H. Jiang, H. Shinjoh, S. Matsumoto, Angew. Chem., 2008, 47, 9303-9306. [2]J. Jones, H. Xiong, A.T. DeLaRiva, E.J. Peterson, H. Pham, S.R. Challa, G. Qi, S. Oh, M.H. Wiebenga, X.I. Pereira Hernández, Y. Wang, A.K. Datye, Science, 2016, 353, 6295. [3]A. Bruix, Y. Lykhach, I. Matolínová, Armin Neitzel, T. Skála, N. Tsud, M. Vorokhta, V. Stetsovych, K. Ševčiková, J. Mysliveček, R. Fiala, M. Václavů, K.C. Prince, S. Bruyère, V. Potin, F. Illas, V. Matolin, J. Libuda, K.M. Neyman, Angew. Chem., 2014, 53, 10525-10530. [4]A.M. Gänzler, M., Casapu, P. Vernoux, S. Loridant, F.J.C.S. Aires, T. Epicier, B. Betz, R. Hoyer, J.D. Grunwaldt, Angew. Chem., 2017, 56, 13078-13082.
Fichier non déposé

Dates et versions

hal-01825035 , version 1 (28-06-2018)

Identifiants

  • HAL Id : hal-01825035 , version 1

Citer

G. Ferre, A. Gaenzler, M. Casapu, J-D. Grunwaldt, M. Aouine, et al.. Pt/CeO2 catalysts during model redox sequences: origin of improvement for diesel exhaust. 3rd Fundamentals and applications of cerium dioxide in catalysis, Jun 2018, Barcelone Spain. ⟨hal-01825035⟩
163 Consultations
0 Téléchargements

Partager

Gmail Facebook X LinkedIn More